How to prevent deformation of wooden panel?In storage maintenance, the surface of the wooden template building template should be effectively removed with a scraper immediately after the mold is removed, which is beneficial to increase the number of turnover. If the template needs long-term storage, the surface should be coated with maintenance oil, stacked neatly and covered with rain cloth. In the process of transportation and storage, it is necessary to avoid deformation and aging of the template caused by the sun. Finally, in the construction site, the template should be stored in a flat and dry place, and must be avoided in a place with extreme temperature and humidity.

    What can the used old wooden panel on the construction site be used for?Some manufacturers recycle old templates and return to the factory to refurbish. Some of the ecological board used for decoration are also refurbished from old templates. The price is very cheap, and those who are knowledgeable can watch it from the outside. So consumers should go to the manufacturer to choose a template.

    How to prevent the four sides of the template from lifting during construction work?In construction projects, the four sides of the template should be controlled as far as possible not to warp. Workers who do not pay attention when disassembling the mold, do not stack well, or the template is exposed to the sun, it is easy to cause the four corners of the template to tilt.Once it is found to be warped, nails should be used to smooth the template as soon as possible.The elevation of the control template can be added from the steel bar 50 line to the elevation of the board surface, and it can be directly measured with a level.

 1. In order to control the elevation of the foundation pad, the piling shall be carried out strictly according to the preset elevation of the small wooden piles in the excavation measurement to control the flatness.

2. The construction of the floor brick fetal membrane, using brick tyre molds, brick tyre molds with ordinary red machine bricks, M5 cement mortar masonry, the surface with cement mortar plastering, the yin and yang corners are not less than 5cm in diameter and rounded corners

    The high-end wooden panel produced by Heibao Wood has a high frequency of use and a reasonable price!And the Heibao wood template is reused many times and the average use cost is low. The wood template system uses eucalyptus single material formed by integral extrusion as the raw material, and one piece of wood template can be turned over 12 times for standard construction. The purchase price of a wooden template is evenly spread down and saves a lot of cost compared with the general template.